Each tab has its own table — the set of columns depends on the operation type. The columns repeat the parameters of the regular operation forms (see the relevant sections) but are entered in table form. The ID column is filled automatically.
Drilling
- Origin — the part corner from which X and Y are counted: bottom-left, top-left, bottom-right, top-right;
- X (part), Y (part) — the hole coordinates;
- Depth;
- Side — front, back or one of the edges (for glass only the front is available, for thin parts — front/back);
- Diameter — chosen from the available tool diameters (depends on depth, side and material).
More about the operation — in the section «Drilling».
Grooving
- Side — front, back or an edge (a production setting may limit it to front/back);
- Width of the groove;
- Groove type — closed or open;
- Depth;
- Distance to the groove start — the reference direction (options depend on the chosen side);
- Offset from the side;
- Offset at the start and Offset at the end (optional).
More — in the section «Grooves and groove templates».
Recess
- Side — front or back;
- Length and Width (for a circle they are not editable — set by radius);
- Depth (for glass it is not editable);
- X from center, Y from center — the coordinates;
- Type — rectangle, rounded rectangle or circle;
- Radius (not needed for a plain rectangle);
- Extra (✏️) — the button for processing the edge inside the recess; available only for a through recess (when the depth is greater than the part's thickness).
More — in the section «Recesses and pockets».
General about the mode and saving — in the article «Table input: mode and saving».