The iFurn.pro parts table is built so that an experienced operator can enter a whole part — sizes, count, bands — without touching the mouse. A set of hotkeys works across the table fields. Their full list is built right into the interface: hover over the «?» icon next to a size field and a hint appears.
The key list
- Enter — moves between the row's fields: length → width → count → side bands. At the end of the row, Enter creates a new empty part and moves the cursor to its first field.
- Ctrl+Enter — creates a new part without entering bands: when the sizes and count are typed and the bands are not needed, this combination immediately adds the next row, skipping the band fields.
- Space — switches the band in a side field: cycles through the order's bands in sequence, after the last one — «no edging», then the cycle restarts. Works both in the full mode (dropdowns) and in the quick mode (numbers).
- Ctrl+Space — jumps to the next part: the cursor moves to the first field of the row below.
- ↑ / ↓ — selects the part above or below. The selected row is highlighted; at a page boundary the arrows automatically flip the parts list to the previous or next page.
The typical entry rhythm
Part after part without the mouse looks like this: type the length — Enter — the width — Enter — the count — Enter — you land in the «Top» band — pick the tape with Space — Enter — «Bottom» — Space — and so on through the four sides; the final Enter creates the next part. If the part has no banding, press Ctrl+Enter after the count — and start the next one straight away.
The mouse works too
Next to the count field of a filled part there is a «+» button — clicking it adds a new empty part, like Ctrl+Enter. And clicking any row selects it — like the ↑/↓ arrows.
Where to see the hint
The «?» icon sits next to the length, width and count fields. The hint lists the keys and decodes the quick mode's band color coding: blue — thickness up to 0.6 mm, green — from 0.6 to 1.6 mm, red — over 1.6 mm.